Redmond RJ-916, Руководство пользователя

Страница: 8 / 12

8
Completely unwind the power cord. Wipe the housing with a
moist cloth. Rinse removable parts with warm soapy water and
dry thoroughly before connecting the appliance to an electrical
outlet.
II. OPERATION
Assembly (scheme
A2
, p. 4)
1. Place the juicer base on a flat, hard, horizontal surface. Make
sure that the appliance is unplugged from the mains and the
speed switch is in position 0.
2. Place the waste container on the base.
3. Place the processing chamber on the base so that the edge of
the waste container is secured in the special tab of the
processing chamber.
4. Place the separator into the center of the processing chamber
on the drive shaft coupling. Press on the upper rim of the
separator from both sides so that it lowers onto the coupling
until it stops. Make sure the separator is secured to the shaft
evenly and firmly. Do not apply excessive force!
5. Place the lid with the food supply chamber on the processing
chamber. Install the juice pouring spout.
6. Raise the clamps, latch them onto the plastic tabs on the lid,
and snap them into place by applying slight pressure to their
bottom.
CAUTION! The lid clamps must be fully latched and tightly secured
to the tabs on the lid.
Operation
CAUTION! The recommended time for juicer continuous operation
at maximum speed when processing solid products should not
exceed 1 minute with a break of at least 3 minutes. The appliance
may only be operated fully assembled.
1. Wash fruits and vegetables before juicing, cut into pieces the
largest ones that do not fit into the food supply chamber.
When juicing plums, peaches and other fruits with large pits,
remove the pits first to avoid damaging the separator. Remove
thick or tough skin from fruit (kiwi, mango, etc.) before juicing.
2. Place the juicer on a flat, hard, horizontal surface. Make sure
that the juicer is properly assembled (see the “Assembly”
section), the appliance is unplugged, the speed selector is in
position 0, the food supply chamber is empty.
3. Place a container under the juice pouring spout.
4. Connect the juicer to the mains.
5. Move the speed selector to position I. The motor starts
running. Use this speed setting for juicing berries, soft fruits
and vegetables.
6. To extract juice from hard fruits and vegetables, move the
speed selector to position II.
Do not turn the speed selector further than the limit positions to
avoid mechanical damage!
7. Load prepared fruits and vegetables into the food supply
chamber. Use the plunger to push them through.
CAUTION! Load products into the juicer only while the motor is
running.