RedBack Laser EGL624, Инструкция по эксплуатации

Страница: 10 / 16

10
EGL624
TM
OPERATING INSTRUCTIONS cont.
Manual Levelling Mode
V-W-S Vibration & Wind Sensor Setting
Manual mode can be used to simulate a manually levelling laser thus allowing
you to set the laser up at any angle and allow the laser to rotate. This can
be usefull for setting large manual grades on dam walls or indoor alignment
such as roof lines or balustrades.
In manual mode you can also set slopes (grades) on both axis at the same
time, however, “V-W-S” and “TILT” cannot be used and any disturbances of
the laser will not be indicated to the user.
• To enter manual mode press and hold Slope/Manual button note
short press will enter slope mode see page 8. Press and hold to exit.
• To set dual grade follow same instructions as pages 8/9, select axis and
slope beam, select second axis and slope that beam.
The EGL624 continuously self levels for utmost accuracy, in high winds or
vibrations the laser will stop rotating to re-level this may be inconvenient by
slowing down your work, however, by selecting V-W-S button the laser
continually re-levels but does not stop rotating whilst doing so.
An added feature in vertical rotation and using manual mode can be used to
slope the dot laser for setting manual pipe grades. Press the Slope/manual
button 3 times quicklt on the keypad (press hold on remote) manual
LED will light and use slope direction buttons on the remote to slope
up and down the dot.
www.redbacklasers.com.au