RedBack Laser EGL624, Инструкция по эксплуатации

Страница: 9 / 16

9
Setting a Grade
Following is a method of setting a grade using the slope (grade) buttons as
previously discussed. Here we will show setting a single grade on the X axis,
for a dual grade simple repeat the process on the Y axis (Manual Mode Only).
Set up the laser aligning the X axis with the direction of the required grade
rise/fall, the laser can be placed anywhere on site as long as the X axis runs
parallel with the desired grade.
For this example we want a grade of 1 in 60 or 1.667% or in other words for
every 6m (6000mm) travelled away from the laser along the X axis we want
the laser plain to tilt down/up 0.1m (100mm).
To achieve this measure out 6m away from the laser along the X axis and
hold the staff at this point slide the receiver up/down the staff until the
receiver indicates level (see receiver instructions page 10).
Then making a note of the height on the staff slide the receiver up/down the
staff 100mm, this is now the height the laser needs to be hitting to be setting
a 1 in 60 slope or grade.
Using the remote, select grade mode on the X axis and use the Slope Grade
Direction buttons to slope the laser until the receiver shows level.
The Grade is now set at 1 in 60 or 1.667% on the X axis and anywhere
parallel to the X axis on site.
Chart below gives a range of grades and the distance the receiver shifts all
based a 5m distance of staff away from laser.
GRADIENT % DISTANCE LASER (M) MOVE RECEIVER (MM)
1 IN 20 5 5 250
1 IN 30 3.3 5 167
1 IN 40 2.5 5 125
1 IN 60 1.66 5 83
1 IN 80 1.25 5 63
1 IN 100 1 5 50