12
3
MONITOR INFORMATION
3.7
Failure Information
Failure Info
This screen shows any fault information that has occurred with
the solar panel or battery connection and voltage limits:
Failure Info.
3.8
Meter Parameters
Meter Parameters (Screen 1)
This screen shows the SRPA remote monitors model number, software version and serial number:
Type
The remote monitors part number (SRPA-RM)
Meter Para.
Ver:
SN:
Type:
H02.02+S02.02
201510160000001
SRPA-RM
Ver
The software version, for REDARC use only.
SN
The units serial number, for REDARC use only.
Meter Parameters (Screen 2)
This screen shows and allows changes to the time duration of the display default screen switching and
backlight time:
Sw — Pages
Timeout / time delay in seconds before the screen
defaults back to the monitoring default page.
Meter Para.
Bklight:
Sw-Pages:
020S
000S
Bklight
The led backlight illumination time duration,
adjustable from 1 – 999 seconds.
ICES Declaration: CAN ICES-003 (B) / NMB-003(B)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference.
2.
This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment intro an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by (the party responsible for compliance) could void the user’s authority to operate the
equipment
