Redarc BMIS series, Инструкция

Страница: 3 / 20

1. Ensure that a correct grounding point is used. Bad grounding of the unit will result in poor or no operation.
2. Do NOT use the BMIS to shut off the engine except in an emergency or for routine testing. Use the ignition
key as per normal vehicle operation. It is recommended for an engine shutdown test, to perform this on a fully
charged battery, or allow a few minutes of engine operation beforehand to recharge the battery as much as
possible. Following these recommendations will minimise the possibility of damage or accelerated wear to
vehicle electrical systems.
3. Ensure unused holes in the connector are filled with cavity plugs as contamination ingress may damage the
BMIS or connector.
4. To prevent contamination ingress, do not insert multiple wires into a single Deutsch connector terminal.
5. For vehicles fitted with SCR / Adblue, it is recommended to restart the truck engine immediately after testing
if isolating via the BMIS. Allow 30 seconds minimum or as per the manufacturer’s recommendations between
key off and isolating the BMIS to allow the SCR system to purge. Refer to the Vehicle manufacturer’s manual
for further information.
CONTENTS
Table of Contents Page
Warnings & Safety Instructions 01
Contents 02
Specifications 03
1. Installation
04
1. Mounting the BMIS 04
2. Wiring Connections 09
3. Data Connector Wiring Diagram 10
2 User Guide 11
1. Operating the BMIS 12
2. LED Indication 12
3. Faults 12
1. LED Fault & Self-test Conditions 12
2. Flashing LED Diagnosis 12
3. Troubleshooting 13
1. Remote Switch 13
2. Troubleshooting Flow-chart 13
3. Battery Not Charging 14
4. FAQs 14
5. Tech Tips 14
6. Maintenance and Cleaning 15
7. Standards & Testing 16
8. Notes 17
9. Two Year Warranty 18
2
WARNINGS & SAFETY INSTRUCTIONS