RED ROCKET-X INSTALLATION INSTRUCTIONS
COPYRIGHT © 2015 RED.COM, INC
955-0033, REV-E
|
23
9. Plug the Windows-based computer 6-pin PCIe power cable into the RED ROCKET-X. Make sure that the
latch of the power cable aligns with the corresponding slot on the RED ROCKET-X.
10. If you are using the HD-SDI slot filler, follow the instructions below to install and connect the HD-SDI slot
filler:
For more information, go to
“Supported HD-SDI Signals” on page 46
.
A. Remove one (1) free slot bracket from the system. Depending on your Windows-based computer, you
may need to use a Phillips #1 screwdriver to remove the slot bracket.
B. Slide the HD-SDI slot filler into the empty slot so that the SDI Out B connector is toward the back.
CAUTION:
Ensure that the HD-SDI slot filler or connectors DO NOT contact other components inside the
computer.
C. Secure the HD-SDI slot filler. Depending on your Windows-based computer, you may need to use a
Phillips #1 screwdriver to install a screw that attaches the HD-SDI slot filler to the computer.
D. Connect the SDI Out A cable on the HD-SDI slot filler to the SDI Out A connector on the RED ROCKET-X.
The SDI Out A connector is the right connector when the RED ROCKET-X is installed.
Connect Power to
RED ROCKET-X
Install HD-SDI
Slot Filler