WARNING: DO NOT ATTEMPT TO OPERATE THIS HEATER UNTIL YOU HAVE
READ AND UNDERSTAND ALL PRECAUTIONS. FAILURE TO DO SO CAN RESULT
IN PROPERTY DAMAGE, SERIOUS INJURY, OR DEATH.
Before Lighting
The gas fire pit should be thoroughly inspected before each use, and by a
qualified service person at least annually .
If relighting a hot gas fire pit, always wait at least 5 minutes.
5. When burner is lit, turn the control knob to
desired heat output position between "LOW"
and "HIGH".
6. Press down and turn the control knob
clockwise to "OFF" position to shut down the
appliance . Turn off cylinder gas valve.
Lighting instructions
1. Make sure control knob is in the "OFF"
position.
2. Turn LP cylinder gas valve to fully open
position.
3. Press down control knob and turn it
counter clockwise to "LOW" position.
4. If the burner is not lit, press down the
control knob and turn clockwise to "OFF"
position, repeat from step 3 after 5 minutes.
Flame Characteristic
Normally the burner flame is yellow . If the burner flame
is blue and very small, please check the gas cylinder, as it
may be low gas pressure or empty. If there is enough gas
in the cylinder, please contact customer service to change
the burner of the gas fire pit.
If flames lift away from burner or backfire happens, or
produce thick black smoke, the fire pit should be turned
off immediately . The fire pit should not be operated
again until the unit is serviced and/or repaired by a
qualified service technician.
Page 14 of 19
