PROGRAMMING MODULE #3 - PROGRAM FUNCTIONS ACCESSIBLE WITH FRONT PANEL LOCKOUT
This programming module programs what is accessible through the front
panel when the PGM.DIS. pin is connected to common
(COMM. TBA #5)
.
Note: The term “Quick Programming” is used to refer to the ability to change the
information that can be accessed from the front panel when the “PGM.DIS.”
terminal is connected to “COMM.”.
DISPLAY ALARM VALUES
If the alarm option is installed, this selects whether the alarm values will or
will not be displayed.
“dSP AL” < > “yES” or “NO”
ENTER ALARM VALUES *
If
“YES”
was selected for display alarm values, this will select if alarm values
may be modified from the front panel.
(If “NO” was selected for display alarm
values, then this step will default to “NO” and will not be displayed for
selection.)
“ENt AL” < > “yES” or “NO”
DISPLAY HYSTERESIS VALUES
If the alarm option is installed, this selects whether the hysteresis values will
or will not be displayed.
“dSPHYS” < > “yES” or “NO”
ENTER HYSTERESIS VALUES *
If
“YES”
was selected for display hysteresis values, this selects whether
hysteresis values may be modified from the front panel.
(If “NO” was selected
for display hysteresis values, then this step will default to “NO” and will not be
displayed for selection.)
“ENtHYS” < > “yES” or “NO”
RESET LATCHED ALARMS
If the alarm option is installed, this will select if a latched alarm
(s)
can be reset
from the front panel.
“rSt AL” < > “yES” or “NO”
DISPLAY PEAK/VALLEY MEMORY BUFFER
If the totalizer/linearizer option is installed, this selects whether peak and
valley buffers will be displayed.
“dSPbUF” < > “yES” or “NO”
RESET PEAK/VALLEY MEMORY BUFFER *
If
“YES”
was selected for the previous step, this selects whether the peak and
valley buffers may be reset from the front panel.
(If “NO” was selected, then this
step defaults to “NO” and will not be displayed for selection.)
“rStbUF” < > “yES” or “NO”
SELECT DISPLAY **
If the totalizer/linearizer option is installed, this selects whether the display
can be switched from input display to total display and from total display to input
display.
Note: When “NO” is selected, the display mode that was being displayed before
entering programming, will be the only display accessible.
“SELdSP” < > “yES” or “NO”
* This sequence may be subject to being locked out due to other
programmed sequences.
** This function operates independent of the state of the “PGM.DIS.” pin.
-10-