15
4
27
28
29
31
30
32
Click!
SEAT BACK
- The seat back has several positions.
- To change positions, press on the pistons located on either side of the chassis (10)
and push down or raise them until the required position is reached (11).
WARNING
: Make sure that the reclining position is correctly locked in place, "click"
heard.
FRONT WHEELS SWIVEL OR FIXED
- To lock them, align the front wheels by pushing the stroller forwards then push down
on the wheel locks, "click” heard (12).
- To disengage them, lift up the wheel locks (12).
WARNING
: This stroller is not suitable for running or skating.
WARNING
: The swivel wheels allow greater manoeuvrability of the stroller. Over
rough grounds, it is strongly recommended that the front wheels be used in the fixed
position.
HOOD and BUMPER BAR set
The stroller includes a hood and bumper bar set already in place.
- To remove the set, undo the buckle behind the seat back (13).
- Press in, one after the other, the white buttons located on either side of the stroller
then lift up the set (14).
- To replace, position the block on the chassis as shown (14) with the bumper bar
raised. Slot the ends into the places for them, above the white buttons located
either side of the chassis, until ‘click’ heard.
- Fasten the buckle located behind the seat back (13).
- The hood is equipped with a sunshade and a window whose fold back flap can be
held in place with Velcro as shown (15).
- The bumper bar can be removed from the hood:
Push it upwards as high as possible then push one side inwards to release the
articulation (16).
To replace it, inverse the procedure.
PLEASE NOTE: The bumper bar cannot be installed without the hood.
HANDLE
The handle position can be adjusted.
- With the hexagonal Allen key included, loosen the two handlebar clamps on the
handle (17), adjust the height position then retighten them.
The stroller includes a pump, an inner tube and a hexagonal Allen key for adjusting the
handle.
4. ACCESSORIES (included with the stroller)
GB
25
26
Click!
