Recsea WHS-RX100Mk 3, Руководство пользователя

Страница: 8 / 12

HANDLING PRECAUTIONS
The Port Lens is manufactured using hard coat acrylic. When cleaning use a clean soft cloth
taking care not to scratch it.
INTERNAL AND EXTERNAL STROBE
※
For heavy strobes and lights please use optional Grip & Tray Assembly and compatible
connector.
※
While in the housing, the camera's on-board strobe can be deploy using the housing Flash
Pop-up Switch. The DSC-RX100 III camera on-board strobe does NOT close when the
camera is turned OFF. Use the housing Flash Close Lever to manually close the strobe
before removing camera from housing.
※
Use the Strobe Mask-External Strobe Connection Mount to connect external strobe fiber
optic cable.
Connecting fiber optic cable for external strobe use:
CAUTION! Store Strobe Mask-External Strobe Connection Mount and Screw in a secure
place so as not to lose them.
1. Using the Strobe Mask-External Strobe Connection Mount Screw, attach the Strobe Mask
-External Strobe Connection Mount by screwing it into the Screw Hole provided.
2. Insert bare fiber optic end into Fiber Optic Sockets provided at the Mount.
※
Two (2) screw holes are provided at the bottom of the housing for use in attaching
Seatool/Recsea genuine tray and grip assemblies.
CAUTION! Seatool/Recsea STRONGLY recommends the use of Seatool/Recsea genuine
tray and grip assemblies listed below under OPTIONS. Leakage or damages due to the use
of non-genuine options are NOT covered under warranty.
※
The Accessory Shoe on top of the housing can be used for installation of a target light.
Please be mindful of the weight of the light(s) you intend to use. For heavy lights and
strobes please use Seatool/Recsea genuine tray and grip assemblies.
※
Please refrain from using lights attached to the Accessory Shoe as a carrying handle.
CAUTION! Damage is irreparable.
MAINTENANCE
CAUTION! Allowing saltwater and contaminants to dry on housing can damage functions and
O-Rings possibly causing water leakage. Clean with fresh water only, using a soft, dry cloth
to wipe away water.
※
We recommend a complete housing overhaul once every year.
1. After use in salt water, wash off salt and other contaminants by soaking empty housing
thoroughly in a bucket of fresh water (lukewarm) for 10 to 20 minutes.
2. Manipulate all buttons and dials several times to flush out salt deposits and other
contaminants.
3. Wipe any water off housing with a soft dry cloth.
4. Open Back Cover.
5. Using the O-ring Removal Pick, remove O-ring.
6. Clean O-ring grooves and contact surfaces using a clean cotton swab. DO NOT clean
housing or Lens Port with volatile organic solvents or chemical cleaning agents such as
thinner, gasoline, and benzine, etc.
7. Perform O-RING GREASING & MAINTENANCE as instructed below before re-installing.
6