Recsea WHS-RX100Mk 3, Руководство пользователя

Страница: 7 / 12

To OPEN, press Lock Lever while pulling Secure-Latch away from housing main body.
To CLOSE, press Secure-Latch into place making sure the latch on the underside is properly
placed in the Secure-Latch groove attached to the main housing body. Push into the locked
position. Double check to make sure it is firmly locked into place.
INSTALLING CAMERA
CAUTION! Before using, please be sure the test the housing (without camera) in bucket or
aquarium if available. After use in salt water, rinse thoroughly in a bucket of fresh water
without fail, pressing all buttons several times to flush out salt deposits and other
contaminants. Allowing saltwater and contaminants to dry on housing can damage functions
and O-ring. Clean with fresh water only, using a soft, dry cloth to wipe away water.
※
Please perform proper Housing and Port O-RING MAINTENANCE prior to installation.
※
Please conduct the following operations in a clean area with low humidity and dust.
1. Attach Camera Flash Protection Cover as show in the below image to protect camera
flash from being scratched or dented when excessive force is applied the Flash Close
Lever.
2. Make sure the housing Mode Dial is pulled (or pushed) outward away from housing, and
camera flash is closed. If these steps are not taken, the camera may not seat properly
into housing and may caused dials and lever not to function as intended
3. Check camera settings, battery is charged and media storage capacity is sufficient.
Slowly and carefully install camera making sure camera does not to hit housing's internal
controls. If the camera is not inserted correctly, buttons, dials, and levers may not work
properly.
4. After performing O-ring Maintenance, carefully close back cover making sure nothing is
caught between the Secure-Latch and housing. Push Secure-Latch into the locked
position making sure the Lock Lever is in the locked position. Double check to make sure
the Secure-Latch is securely locked into place.
REMOVING CAMERA
CAUTION! After use in water, water will remain in gaps between housing, back cover and
Secure-Latch. Wipe any water off housing with a soft dry towel to prevent water from falling
on camera.
1. Pull Mode Dial upward away from Housing.
2. Press Lock Lever while pulling Secure-Latch away from housing main body . Open back
cover.
3. Tip Housing backwards, gently sliding camera out of housing.
5