TonerRefillKits.com
RechargX™ RX201X v1
Mon - Fri 8am - 5pm ET © 1995-2011 ReChargX™, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the
2012.01.10
800.527.3712 or 352.343.7533 ReChargX™ and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
Page 5 of 9
Step 8: Clean the Area Around the Toner
Hopper Hole Before Sealing
Unfold the yellow/orange “toner grabber” cloth
from the ReChargX™ RX201X Premium Print Toner
Refill Kit and stretch it along both dimensions (it will
stretch considerably in one dimension and not the
other). Stretching the yellow/orange toner grabber
cloth activates the toner retaining substance that is
embedded within the cloth.
You will be using this cloth to clean the outside
of the toner hopper hole to ensure the new
hopper plug will be applied firmly and securely
to the cartridge, as shown in figure 8.
NOTE:
Only use the toner grabber cloth on the
exterior of the toner cartridge around the toner
hopper hole area. Do not use the cloth to clean
any of the internal components or the cartridge
developer roller.
Step 9: Plug the Toner Hopper Hole
Remove the new plug from your ReChargX™
RX201X Premium Toner Refill Kit and place the
plug over the hopper hole, press firmly around
the entire perimeter of the plug to make certain
the plug sits securely inside the toner hopper
hole (figure 9).
NOTE:
Do not press hard enough for the plug
to go through the hole and into the cartridge.
Step 10: Locating the Cartridge Gear
End-cap
The rest gear is essential to ensure that the cartridge
is recognized by the printer as being full. Also, it
resets the voltage bias (this eliminates light print).
To begin, turn the toner cartridge on its end, so
that the cartridge gear end-cap is facing toward
you, as shown in figure 10. (The opposite side
from the fill cap).
Figure 8:
Clean the area around the toner hopper hole
Figure 9:
Reinsert the toner hopper plug
Figure 10:
Orient the toner cartridge
