Rebel TOOLS RB-1011, Руководство пользователя

Страница: 40 / 160

40 EN
Work mode selection
Slide the work mode switch maximally left until it locks in place (you will hear a click) to the
marking for impact drilling. Slide the work mode switch maximally right until it locks in
place (you will hear a click) to the marking for drilling without impact.
Use carbide-tipped drill bits and select impact drilling when drilling in hard materials such
as brick, tile, concrete etc.
Select drilling without impact when drilling with twist drills, hole saws etc., in soft materials.
Rotation direction adjustment
The power tool has been equipped with rotation direction switch which is placed above the
ON/OFF switch:
• To achieve right rotation, push the rotation direction switch maximally left.
• To achieve left rotation, push the rotation direction switch maximally right.
NOTE : The drill will not run unless the rotation direction switch is pushed fully to the left or right.
Avoid running the drill at low speed for extended periods of time as it may cause the drill to
become overheated. If this occurs, cool the drill by running it without a load and at full speed.
Removing a work tool from the tool holder
1. Push the locking sleeve back and hold it.
2. Remove the work tool and release the locking sleeve.
3. Clean the work tool and rub it over with a small amount of machine grease.
SDS chuck
1. Insert the work tool as far as it will go in the chuck, then rotate the sleeve left to tighten
the chuck.
2. Rotate the sleeve right to open the chuck jaws what allows to remove the work tool
safely.
Speed adjustment
The speed is adjusted depending on how far the ON/OFF switch is pressed. Light pressure
on the ON/OFF switch results in low speed. Further pressure on the ON/OFF switch
increases the speed.
Note: You might hear a whistling or ringing noise from the ON/OFF switch during use. This
is a normal part of the ON/OFF switch function.