11
Battery Pack Operation
The equipment is powered by a lithium-ion battery. The
battery pack is completely sealed and maintenance free.
Battery Charge Level Indicator
The battery pack equipped with a push button for checking
the charge level, Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
·
All 4 lights flashing: Battery is full.
·
3 lights flashing: Battery charge level high.
·
2 lights flashing: Battery charge level is decreasing .Stop
Work as soon as possible.
·
1 lights flashing: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery’s service life will be greatly shortened.
NOTE
: If the charge level button does not appear to be
working, place the battery pack on the charge and charge as
needed.
NOTE
: Immediately after using the battery pack,the charge
level button may display a lower charge than it will if
checked a few minutes later. The battery cells “recover” some
of their charge after resting.
Charger Operation
WARNING
！
Charge only Bigayo lithium-ion battery
packs in compatible Bigyao lithium-ion battery charges.
Other types of batteries may cause personal injury and
damage.
To reduce the risk of electric shock. Do not allow water to
flow into the charge’s AC/DC plug.
When to charge the Ecosharp® iBAT40XR
Lithium-lon Battery
NOTE: The Bigyao battery packs do not develop a “memory”
when charge after only a partial discharge. Therefore, it is not
necessary to run down the battery pack before placing it into
the charger.
. Use the battery charge indicator lights to determine when to
charge your Bigyao lithium-ion battery pack.
.You can “top-off” your battery pack’s charge before starting
a big job or after a long day of use.
Charging the Battery
1. Open the battery compartment cowers. Slide the push
lock button on the battery to remove the battery pack
from the base unit (Fig.10).
2. Check that the mains voltage is the same as that
marked on the rating plate of the battery charger.
Then insert the charge’ plug into the electrical wall
outlet. When you plug in the charge, the top green
light will illuminate and stay green.(Fig.11).
3. Place the battery pack into the charger by sliding the
pack as shown to lock it into position . When you insert
the battery into the charger, the bottom red light will
illuminate to indicate that the battery is charging.
4. When the bottom light turns green ,the battery is
fully charged. (Fig 12)
