18
Troubleshooting
·
Remove the battery from the compartment before carrying out maintenance on the machine or when checking that its
parts are in proper working order.
·
To avoid unnecessary hassles, consult the following table before contacting customer service with any mechanical
issue.
Problems
Possible Cause
Possible Solution
Machine refuses to start
·
Power failure/Battery is not
inserted well
·
Check to make sure the battery has
sufficient power and is inserted well
Fluctuating pressure
·
Pump sucking air
·
Valves dirty, worn out, or stuck
·
Pump seals worn out
·
Checking the hoses and connections are
airtight
·
Clean or replace valves/seals
·
Please call the local customer service
center for assistance
Machine stops
·
Thermal sensor activated
·
Nozzle partially blocked
·
Battery is flat
·
Leave the washer for 5 minutes to cool
down
·
Clean the nozzle
·
Charge the battery.
Machine pulsating
·
Air inlet hose
·
.Inadequate supply of mains
water
·
Nozzle partially blocked
·
Water filter blocked
·
Hose kinked
·
Allow machine to run by holding the
trigger until regular working pressure
resumes
·
Check
that
the
water
supply
corresponds to the specifications
required
·
WARNING!
Avoid using long, thin
hoses (minimum 1/2 in. diameter)
·
Clean the nozzle
·
Clean the water inlet filter
·
Straighten out the hose to remove any
kinks/blockages
Machine often starts and
stops by itself
·
Pump/spray gun is leaking
·
Trigger mechanism is broken
·
Please call the local customer service
center for assistance
Machine starts. but no
water come out
·
Pump/hose or accessories frozen
·
No water supply
·
Water inlet filter blocked
·
Nozzle blocked
·
Wait for pump/hose or accessories to
thaw
·
Connect inlet water
·
Clean the water inlet filter.
·
Clean the nozzle
