14
1.3.2 Assembling
1.4 Assembly or removal of the filter
Fit the filter over the float cage & secure
with the retainer band. To remove, first
remove the retainer band, then remove
the filter from covering the filter cage.
IMPORTANT:
Make sure the filter is
completely covering the filter cage, there
are no gaps between the filter & thelid.
It's very important to assembly filter
properly to reduce the risks of leaks and
possible damage to the vacuum.
2.1
Vacuuming Dry Materials
2.1.1
The filter must always be in
correct position to reduce the risk of
leaks and possible damage to vacuum.
Make sure that the filter is completely
covering the filter cage and that
retainer band is as close to the lid as
possible. Make sure there are no gaps
between the filter and the lid. It’s very
important to assemble the filter to the
cage without allowing any possible leaks
or tears. Any leaks will allow the pick up
media to be blown out the blower port
and
back
into
the
surrounding
environment.
2.1.2
To maintain peak performance of
your vacuum when picking up small dirty
such as sawdust, it may be helpful to
empty the dust drum and clean or
replace the filter at more frequent
intervals.
Note:
The filter should be dry to pick up
dry material. If you use your vacuum to
pick up dry dirty when the filter is wet,
the filter will clog quickly and be very
difficult to clean. In case the filter gets
wet, replace it before continuing dry
pickup.
2.2
Vacuuming Liquids
2.2.1
Removal of the filter is highly
recommended for wet pickups.
2.2.2
This wet/dry vacuum is equipped
with a float mechanism which will rise
automatically to cut off the airflow
when the liquid in the drum reaches a
predetermined level. When this happens,
turn off vacuum, unplug the power cord,
and the empty the dust drum. You will
know that the float has shut the airflow
off because the suction ceases and the
motor noise becomes higher in pitch,
due to increased motor speed. The
liquid capacity may vary with the rate of
pick up.
2.2.3
Be sure to replace filter after wet
pick up. Never pick up dry dirty without
the filter properly installed.
IMPORTANT:
To reduce the risk of
damage to the vacuum, do not run
motor with float in raised position.
WARNING:
Never leave vacuum running
while unattended.
1
2
2
EN
2. How to operate
