P a g e
| 3
CL4000PRO User’s Manual
Reach/BTX
2
Installation
2.1
Connect Cables
a)
Connect the sources to the input connectors on the CL4000PRO modules. To loop out the
signals for local monitoring or content repurposing, connect a corresponding cable to the
output for that module and terminate it at a display or other terminal equipment.
b)
Connect the audio source to the audio input port Line In with an RCA type unbalanced
line level Hi-Z audio source such as an audio mixer, DSP, or other audio equipment. If there
is microphone input, connect a balanced microphone cable to the phoenix connector
labelled Mic In.
c)
To control the camera PTZ, connect the camera PTZ to the device serial port.
d)
Connect a network cable to the CL4000Pro LAN port, so that the device will be connected
to the network planned by the network administrator. Connection to a 1000BaseT switch
is highly recommended.
e)
Connect the power brick to the DC in connector.
2.2
Startup and Shutdown
Before starting up the device, please make sure that the cables are properly connected, and
then turn on the power switch on the rear panel of the device. The power LED of the CL4000PRO
will be constantly ON after the device starts up. The HDD LED will flash constantly until the startup
completes.
Before shutting down the device, please confirm that all recordings are stopped and that the
session parameters have been saved. Then turn off the power switch on the rear panel of the
device, to protecting the hard disk and prevent data loss.
