2 - Operation
NOTE
:
If you have more than one "tank" enabled, on selecting "Nozzle Setup", the instrument
will first prompt you to select the channel to which the nozzle setup will apply (fig. 12)
before displaying the "Nozzle Wizard" screen.
Alternatively you can press the key in the Nozzle Wizard to select the tank to
which the Nozzle Wizard refers.
2.3.1
Selecting the Target Speed
1 From the SETUP page, press .
2 Key-in the speed and press to start the speed simulation. The display will revert
to the MAIN screen and the icon will start flashing.
Speed simulation can only be started with the sprayer stationary. To stop speed
simulation, press the key or move the vehicle a short distance.
2.3.2
Using the Nozzle Wizard
1 Set your Target Speed as above.
2 Key-in the target application rate either on the MAIN page or on the "Nozzle Wizard"
and press .
3 Cycle through the nozzles with the key until a nozzle is reached closest to the
desired spraying pressure and press .
4 Fit the appropriate nozzles to the sprayer.
2.3.3
Editing the preset Nozzle type
If the nozzles fitted do not correspond to any of the 8 preset types, then you must
select one of the nozzle types A to H and edit the calibration data according to the
nozzle manufacturers data.
Press the on the Nozzle Wizard to edit nozzle data.
Figure 12
Selecting the "Tank" in the
Nozzle Wizard
15
