RDC GSM-ICE3, Руководство по установке

Страница: 15 / 16

Hunter-Pro
832, 896, 8144
Panel programming
Communication [1][3][ENTER]
Access MS1 options [ENTER]
Ensure that the MS1 protocol options display 0
and 230 and T=1.
Modify MS1 reporting [ENTER]
Prog. test/interval time [ENTER]
ID account 000000 [ENTER]
Phone no. [1][2][3][4]
[END]
Configure account no. [NEXT] [ENTER]
Add MS1 phone no. [1][2][3][4]
Programming mode [1][2][3][4]
Set radio test interval [ENTER]
Radio no. [1][2][3][4] [ENTER]
Set dials [3]
Check other options required to be activated as
per installation requirements.
Tone dial +
No dial tone check +
Enable comm methods PSTN primary +
all others –
Exit programming [END] repeat
Set rings [1]
Modify coms. option [#] for + to -
Connect T-Line +
Add MS2 and MS3 phone no.s if used.
External line leave as is [ENTER]
ACK wait time leave as is
Away arm/disarm using Relay1
On-board panel key switch zone is used for
arm/disarming. Connect Relay1 as per the
diagram. No resistor required.
Zone 1 Zone 7 Zone 8 - + KEY SIREN RELA
Y
BUS ALARM
PIMA HUNTER-PRO
12V
SET
LINE
LINE
Relay 1 Relay 1 Relay 2
+
-
RELAY EXPANDER GSM GATEWAY
Zone resistor
Tamper resistor
DEOL Connection SEOL Connection
Stay mode key switch arm/disarm via the
app is not supported on this panel.
NOTE:
Stay arm/disarm can be done via the keypad.
Although not functional, the away arm
function is still shown in the mobile app.