RCI 186M, Руководство оператора, Страница: 17 / 72

16
Setup Instructions
Convert from Shipping to Field Setup
Each unit is shipped with the tongue in a
raised position. See Figure 7. Perform the
following actions to prepare the machine
from shipping configuration to field
configuration:
1) Release unit from shipping skid by
cutting shipping straps.
2) Remove the hitch from the skid. See
Key 1 Figure 7. Release the
shipping strap from the hitch. See
Key 1 Figure 8. Retain hardware
and Strap.
3) Using a lift or other device, safely lower
the tongue until the Latch can fit the
pin in the rear hook point of the
latch. See Key 2 Figure 8.
4) Install the hitch into the tongue and
replace the ¾” bolts provided.
Torque bolts to 280 lb-ft (380 Nm).
See Figure 9.
5) Install Jack Stand and Hydraulic Hoses
as indicated in Figure 9. Slots are
provided for hose storage when
not in use.
6) Lift the unit with a forklift from the rear
through the fork pockets in the main
frame. Take care to not damage any
tine bars or tines. Secure the merger
to the forklift in a safe manner. Do
not move the merger fore/aft with the
forklift.
7) Place the merger on blocks for safety.
Install spindles and tires. Tighten all
hardware properly. Remove
shipping skid, remove safety blocks
and lower unit to the ground.
Figure 7. Shipping Configuration
Key 1 - Hitch
Figure 8. Shipping Lock
Key 1 – Shipping Strap Key 2 - Latch
Figure 9. Htich Installation
Key 1 – Hitch Key 2 – Bolts
Key 3 – Jack Stand Key 4 – Hoses
Key 5 – Hose Mounts