ENGLISH
DMU 6100 SOFTWARE MENUS
After turning the device on, the LCD displays
the writing:
Then, the system starts recognizing all console types (delegate, chairman, interpreter); during this
time, every console red light-ring is lit.
Each interpreter console is to be directly connected to a dedicated input and cannot be added to
the lines L1 / L2.
If there are more than 3 chairmen (“chairman error”) or more than 30 consoles in each line (“dele-
gate” error), the system reboot will be stopped. The console red light-rings help to find out in which
line segment there could be a console wrongly set.
According to the error, the LCD displays:
After problems have been found, press and hold for 3 secon-
ds the SET key and then press the ENTER key (or turn the
device off) to reboot the system.
If all is OK, the LCD displays:
where “x”, “y” and “zzz” are respectively the found chairmen
(0-3), interpreters (0-2), delegates (0-60; with the optional
board DEC 6104: 0-180).
After the initial check, all console red light-rings are lit for 2 se-
conds (delegates and interpreters) or 4 seconds (chairmen).
This allows to verify how many consoles (and their effective
places) are set to either delegate / interpreter or chairman.
Finally, the LCD will display the present operating mode
(e.g. FREE DISCUSSION).
The operating modes will be explained in the following
paragraph about the MODE key.
When the LCD shows the present mode (default), the keys
can be used to adjust the central unit internal loud-
speaker volume (max.: 16; default: 10; mute: 0).
The LCD displays:
Press the
MODE
key to enter and edit
the operating mode
menu.
FORUM DISCUSSION
REV. 1.0
CHRM INIT ERROR
PRESS SET, ENTER
DEL INIT ERROR
PRESS SET, ENTER
CONSOLE: CHRM x
INTER y DEL zzz
“chairman”
error
“delegate”
error
MICROPHONE MODE
FREE DISCUSSION
VOL MONITOR SPKR
IMPORTANT
IMPORTANT: All MODE menu parameters can be edited even if the discussion
is in progress. New settings are not retroactive. Example: if the max. number
of microphones that can be activated (or the booking quote) is changed, this
setting will only take effect for the following activation requests.
The firmware release is shown (i.e. 1.0)