
20
5. TURNING ON THE SYSTEM
Before turning on the units with primary 230 VAC power supply make sure that the batteries are disconnected
on every DXT 3000 unit.
Start from the LAST SLAVE unit of the INTERLINK chain.
5.1. SLAVE UNIT CONFIGURATION
Proceed with the following instructions for all the SLAVE units.
•
Apply all the settings related to the single unit configuration:
•
AUDIO SETTINGS:
•
zone volume, source assign, assign levels, etc.
•
Select emergency message.
•
Spare amplifier configuration (if needed).
•
SAVE CONFIG: wait for the system to reboot.
•
Switch off primary 230VAC supply.
Note: in order to switch off the unit it is not sufficient to move to OFF the dip switch #6 of the main
board, but it is necessary to switch off the primary power supply.
NOTE: according to the characteristics of the installation (in particular for very long INTERLINK bus lenght) it
might be necessary to apply level correction to the two shared audio buses, BM 3804 and BGM. You can apply
these regulation from the front panel of each unit in the following menu:
•
AUDIO SET / BM 3804 / INPUT LEVEL;
•
AUDIO SET / BGM / INPUT LEVEL.
5.2. MASTER UNIT CONFIGURATION
Proceed with the following instructions for the MASTER unit.
•
Apply all the settings related to the single unit configuration:
•
AUDIO SETTINGS:
•
zone volume, source assign, assign levels, etc.
•
Select emergency message.
•
Spare amplifier (if present).
•
DISCOVERY CONSOLE. Before doing the discovery console make sure that all BM 380X consoles (if
present) are powered from local supply. Keep the consoles powered for the following phases.
Содержание DXT 3000
