40
Playback
Playback on a TV Without Audio/Video Inputs
To connect your camcorder to a TV without audio/video inputs, you will need an
optional CRF800 output adapter and an optional coaxial RF cable, such as VH82 or
VH90 shown on pages 42-43. If your TV has AUDIO and VIDEO IN jacks (or is
connected to a VCR), refer to pages 36-39.
Installation
1. Disconnect the VHF antenna from
your TV. Connect the antenna to the
connector on the RF output adapter as
shown above if you are going to leave
the adapter connected to the TV.
Note: If your VHF antenna is the flat
twin-lead type attached by two screws,
you will also need an optional 300/75 ohm
transformer.
2. Attach one end of the optional coaxial
RF cable to the other connector on the
adapter, and attach the other end to the
VHF input on your TV as shown.
Note: If your TV has 300 ohm screw
terminals, you will need a 75/300 ohm
transformer, such as VH54, shown on
page 43.
3. Attach the RF output adapter’s plug
to the audio, RF out, and video jacks
(located under the A/V cover) on the
side of the camcorder.
4. Model Pro848 Only: Make sure the
audio/video IN/OUT switch on the
side of the camcorder is in the OUT
position.
OR
VHF Antenna
CHANNEL
4CH/3CH
Switch
VHF Antenna
OR
Back of TV
Back of TV
Optional
CRF800 RF
Output Adapter
Optional
Transformer
(Such as VH54)
Optional
RF Coaxial
Cable
(such as VH82
or VH90)
Optional 300-75 Ohm
Transformer
VHF
IN
FROM
ANT
VHF