5
Setup and Connections
The Basic connection(pip not available)
The basic connection below (TV and VCR) is the most common
connection and is therefore used to illustrate a single component
connection with your TV. For better sound and picture quality and
multiple component connection information refer to the next section,
Advanced Connections
.
Cables
You will use the following type of cable to make your connection:
Coaxial Cables
: In this connection, two coaxial
cables are used: one connects from an antenna,
cable, or cable box to the VCR, and one connects
from the VCR to the TV. These cables carry both
audio and video signals.
VCR 1
AUDIO
VIDEO
OUT
IN FROM ANT
OUT TO TV
CH3
CH4
CABLE, CABLE BOX, OR ANTENNA
TV
INPUT 1
VIDEO
R
S-VIDEO
L
AUDIO
CABLE/
ANTENNA
INPUT
VCR
CONTROL
R
INPUT 2
VIDEO
S-VIDEO
L—AUDIO—R
AUDIO OUTPUT
AUDIO
L
How to View the VCR
To watch the VCR in this connection tune
TV to Channel 3 or 4.
Later, in the
Interactive Setup
section you
will program the TV to automatically tune
to Channel 3 or 4 when you turn on the
VCR.
This Connection Will Not Allow
You to Use PIP
Your TV is equipped with a single tuner,
which means you must connect with a
second video source using Audio/Video
Cables to view PIP. This Basic Connection
will not enable you to use your PIP, but
will get your TV up and running quickly.
Refer to
Advanced Connections
for
connecting Audio/Video cables to your
VCR or other video component.
To VCR
To cable box (If you do not have
a cable box, then leave this
portion unconnected.)
Once you have completed this connection you may skip to Step 3,
“Connect the IR Controller.”