page |
2
Step 1:
Installation of the motors on the motor mounts
Please slightly loosen the screws with which the motor mount is attached to the boom, then pull
the whole mount off the boom. Thread the motor cables through the provided protection grommet
at the end of the motor mount and screw the motor on the mount. You can put shrink tube on the
motor cables for additional protection.
Step 2:
Push the mounting bracket onto the boom
There are 4 POM plastic snatches and 4 POM plastic hinges/brackets included. Push a bracket
for the folding mechanism on each of the 4 booms. The bracket must be pushed beyond the hole
for the motor cables. Make sure that you get 2 short and 2 long mirror-inverted booms.
Step 3:
Mounting the motors and threading the cables through the boom
Push the motor mounts with the installed motors back onto the boom and thread the motor cables
through the plug at the end of the boom into the tube. Pull the cables out at the other end of the
boom, make sure again that you get 2 mirror-inverted booms each.
Step 4:
Threading the motor cables through the top hole of the boom
After you have threaded the cables through the boom, you have to thread the motor cables
through the top hole at the boom end facing the center frame. We recommend the use of angled
tweezers. First, gently pull the cables out of the boom end as far as possible. Then, separately
bend each cable, put it back into the tube with the tweezers and thread it upwards through the top
hole.
