RC Systems ST-72, Инструкция по эксплуатации

Страница: 50 / 142

ST-72 User's Manual
Document: UM-1007 Revision Level A
44
Figure 2-27
2.5.4.2 CLEAR FAILURE COUNTS
Selecting this option clears the communication failure counter so test can be run or old
data can be cleared after communication ports are configured.
2.6 SECURITY MENU
A password entered in the SECURITY menu allows locking all menus. Viewing menus
is not denied but attempts to edit variables flashes the Locked message on the LCD.
Main Menu
Channel Config
Communication Settings
Security: Unlocked
System
Diagnostics
Alarm Outputs
~
~
~
~
~
~
Lock Code
Modbus Lock Code
User Name
0
Default User
Security: Unlocked
Figure 2-28
2.6.1 USER NAME
Authorized individuals locking the system should first enter a name, phone number, or
other contact information into the 10 digit field so they can be contacted to unlock the
unit at a later date.
2.6.2 LOCK CODE
To lock or unlock the system the correct 4 digit authorization number must be entered
into the
Lock Code field. The ST-72 will ask this 4 digit code to be re-entered and then
it will be lock. Once locked, re-entering the code will unlock the unit.
It is very important to record the 4 digit code. However, if lost the controller may be
unlocked by entering the override code:
8621
2.6.3 MODBUS LOCK CODE
The Modbus database is normally locked. The register 40099 is used to unlock the unit
and allow writes. When written with the unlock code (found in the security menu). The
database unlocks and stays unlocked while writes occur and for 10 minutes of being
idle. The default Modbus lock code is “
1234 ”.