RC Logger 88007RC (Mode 1), Руководство по эксплуатации

Страница: 52 / 60

52 | Maintenance, Care And Repair
19.2.2 Mode 1
The use of the supplied stock transmitter is described here. For your own transmitter refer
to its user instructions and your own configuration respectively.
1. Place the »Xtreme onto an as flat as possible level surface.
2. Power on the transmitter and connect the flight battery.
3. Move the THROTTLE/AILERON lever diagonally into the right bottom position, and
move the ELEVATOR/RUDDER lever fully up vertically. See [ Fig. 28 ] .
4. Hold the levers at their positions until the transmitter emits an ACOUSTIC SIGNAL
and the »Xtreme’s STATUS LED TURNS SOLID GREEN .
5. The calibration has been completed, no drift should be observed. In case the »Xtreme
still drifts, the sensor may be defective or vibrations still remain.
» Replace all 4 motors.
19.2.3 Mode 2
The use of the supplied stock transmitter is described here. For your own transmitter refer
to its user instructions and your own configuration respectively.
1. Place the »Xtreme onto an as flat as possible level surface.
2. Power on the transmitter and connect the flight battery.
3. Keep the THROTTLE / RUDDER lever at zero and move the AILERON/ELEVATOR
lever diagonally into the top right corner. See [ Fig. 29 ] .
4. Hold the levers at their positions until the transmitter emits an ACOUSTIC SIGNAL
and the »Xtreme’s STATUS LED TURNS SOLID GREEN .
5. The calibration has been completed, no drift should be observed. In case the »Xtreme
still drifts the sensor may be defective or vibrations still remain.
» Replace all 4 motors.
Mode 1
Fig. 28
Mode 1 Mode 1 Mode 2
Fig. 29