RC Logger 88007RC (Mode 1), Руководство по эксплуатации

Страница: 35 / 60

Transmitter | 35
R
W B B
Capacitor
W
Fig. 18
1
2
3
Fig. 19
» W : White
» B : Black
» R : Red
2. Route the PPM cable through the lower flight control circuit board and main frame
towards the front orientation LED.
» To best route the wire, make use of the gap near the motor wire socket as shown
in
[ Fig. 18 ] .
» The cable must not obstruct any components of the upper circuit board as this
may influence flight control sensors, leading to poor flight performance.
3. Install your PPM RECEIVER with double sided tape between the battery tray and
front orientation LED. See [ Fig. 19 ] .
» Do not guide any PPM receiver wire antennas above the battery tray.
4. Connect the PPM cable to the PPM receiver. Observe the manufacturer instructions of
the PPM receiver for more information on pin allocation.
5. Replace the canopy.
Once the PPM cable is in place, check if the canopy rubs
against the PPM cable when mounting it. Rubbing
damages the wire insulation, which as a consequence can
cause short-circuiting.
16.4.5 Binding
> Bind the PPM receiver with your transmitter. Refer to the operating instructions of your
transmitter and PPM receiver.
> Use 7 CH mode on Futaba
®
FASST systems! If no PPM receiver is detected, learning
mode will not be activated!