11
8. Software Update LSG
The firmware can be transferred with the Cyclone Pro to the LSG/LSK. The six pin BDM cable
has to be used. The cable can be plugged one to one to the vertical plug J1. The energising of
the target hardware is done via the Cyclone Pro. The jumpers have to be set according to the
picture.
Cyclone Pro Jumper Setting
Anschluss BDM Kabel am Cyclone Pro
The image „LSG-LSK_V01.sap“ can be transferred directly to the Cyclone Pro and contains all
settings..
When programming t
When programming t
When programming t
When programming the sensor head may not be populated !
he sensor head may not be populated !
he sensor head may not be populated !
he sensor head may not be populated !
Attention: In case another tool is used the CPU might be set:
Freescale MC9S08LL08. The voltage of 3V has to be selected
.
At a setting of 5V the micro controller might be destroyed !
The software version will be shown during switch on.
Version 01 = 1 bar at switch on notice
Version 02 = 2 bar at switch on notice
Example: switch on notice LSG :
switch on notice LSK :
