“I” Running boards are On
“O” Running boards are Off
Thank you for choosing RBP! We hope you enjoy your new
Stealth Power Running Boards. We would love to hear about
your experience and see your vehicle decked out with our
products. To share simply tag us using #Rollingbigpower,
#RBP or #RBPStealthPower or DM us on Facebook and
Instagram and visit us on YouTube!
FOLLOW US
OfficialRBP
@rollingbigpower
RollingBigPowerTV
13
1-877-519-9090
INSTALLATION INSTRUCTIONS
Step 27:
Install the left center console trim panel and tuck
the disable switch harness behind the lower dash panel
Step 28:
Remove the 20 Amp fuses from the main
positive and negative 12V power leads on the main
harness. Route the power wires over the wheel well and
into the engine compartment. Connect the ring terminals
to the battery positive and negative posts.
Step 29:
Install the 20 Amp fuses back on the main
negative and positive 12V power leads of the main power
harness.
Step 30:
Connect the battery. Begin with the positive
terminal, followed by the negative terminal.
Step 31:
Open and close all four doors to test the operation
of your new Stealth Power Running boards. Please note that
there is a 4 second delay for the running boards to retract
after the doors are closed.
Step 32:
Open the driver side door and keep the door open.
Flip the disable switch to the “O” or Off position. This will
signal the running boards to retract to the stowed position
and it will disable any further operation until the switch is
flipped to the “I” or On position.
Step 27
Step 30
Step 28
Disable switch
Lower dash panel
