34
MORE PAD INDOOR
Valid for wall only
Temporarily secure mats to the substrate with
solvent-free reinforced double-sided tape, such
as MAPEI Mapecontact, 240 mm wide.
Once the electrical wiring and functional test
is complete, finish by laying a 5x5 mm section
fibreglass mesh reinforcement for coats, to be
fixed with (stainless steel) metal clips or plastic
dowels for coats.
Apply several coats of water- or latex-based
cement mortar that has sufficient elasticity to
withstand the normal temperature fluctuations
typical of an external coating, as well as avoiding
chemical aggression to the polymer.
Proceed with the subsequent application of the desired finish, taking care to ensure
complete adhesion of the finish to the radiant substrate
Warning
10.DISPOSAL
For the polymer:
CER170411
For electrical equipment: CER160216
WEEE Waste Electrical and Electronic Equipment
Italian Legislative Decree 25 July 2005, no.151 “Implementation of Directives 2002/95/EC, 2002/96/EC and 2003/108/
EC and subsequent amendments and integrations concerning the reduction of the use of hazardous substances in
electrical and electronic equipment, as well as waste disposal”.
The crossed-out wheelie bin symbol on the equipment, or on its packaging, indicates that the product, at the end of
its useful life, must be collected separately from other waste and taken to separate collection centres. The cost for
separate disposal of this end-of-life equipment was originally paid for by the manufacturer.
organised and managed by the manufacturer.
The user who wishes to dispose of the equipment included in this system should, therefore, take it to an authorised
centre for separate collection.
Appropriate separate collection for subsequent recycling, treatment and environmentally sound disposal of discarded
equipment contributes to avoiding any negative effects on the environment and health while promoting the reuse and/
or recycling of the materials the equipment is made of. Illegal disposal of the product by the holder will result in the
application of administrative sanctions as provided for by the legislation in force.
Example of stratigraphy:
1. application on the masonry and PAD INDOOR of a layer of solvent-free acrylic primer for absorbent and non-
absorbent substrates, even with residues of old adhesives (such as Mapei Eco Prim T)
2. 1 mm of reinforced glass fibre mesh 10x10 (such as MAPEI Mapegrid G)
3. a layer of pre-blended, two-component, fibre-reinforced, highly ductile, non-combustible cementitious mortar
with pozzolanic reactivity binder based, 5 to 25 mm thick (such as MAPEI Planitop HDM Maxi). The thickness to be
applied depends on the degree of unevenness of the substrate.
4. for surfaces to be tiled, proceed with laying with adhesive
5. a final coat of fine-textured, hydrophobic cementitious smoothing compound for concrete, plastic, glass and
porcelain cladding, 1 to 3 mm thick (such as MAPEI Planitop 200).
Follow the instructions given by the manufacturer of the finishing products for the installation steps and methods.
