10
MORE PAD INDOOR
3. SYSTEM COMPONENTS
The components of the PAD INDOOR system are listed below in this manual.
For further accessories that are not strictly related to the PAD INDOOR system, which may be necessary for the
installation of underfloor heating systems, refer to the general RBM MORE catalogue.
PRODUCT TABLE
Series
Description
3857
Electric heating mat with very low voltage 36 VDC and low
consumption, made of self-modulating semi-conducting
technopolymer for radiant heating on floors, walls and
ceilings, with double copper conductor cord embedded in
the technopolymer Width 310 mm - Supplied in rolls, length
10 or 30 m
3970
Feeder to control very low voltage current modulating
utilities with constant output voltage
230VAC/36VDC - Power output 320 W - watertight IP65
SELV
3858.A
Feeder to control very low voltage current modulating
utilities with constant output voltage
230VAC/36VDC - Power output 600 W – watertight IP65
SELV
3858.B
Feeder to control very low voltage current modulating utili-
ties with constant output voltage
230VAC/36VDC - Power output 1000W
3859
Protective, thermally conductive sheet, to be laid over
the Pad Indoor mat, when the floor installation involves
aggressive cements and adhesives and/or when the laying
distance exceeds 150 mm in order to favour the uniformity of
the surface temperature.
Width 700 mm - Supplied in rolls, length 20 m
3860
Crimp terminal to connect the part of the mat to the
electrical distribution cables.
Supplied in packs of 20 or 200 pcs.
3862
Crimping clamp with flat jaws.
3861
Double-sided, self-amalgamating bituminous tape for
dielectric sealing of the areas affected by the crimping
between terminal, electrical cable and technopolymer. Width
30 mm - Supplied in rolls, length 20 m
