Razorgage Cyclone RazorOptimal, Руководство пользователя

Страница: 19 / 55

Cyclone RazorOptimal User Manual
19 | P a g e
Technical Services, Inc.
Scan Parameters

SCAN START POSITION (FROM LOW LIMIT)
– This variable is the length of material the saw
blade removes with each cut. If all part lengths are off by the same amount from nominal
dimension then the saw kerf may need to be adjusted.

SCAN SPEED
– The speed in inches/sec at which the RazorGage moves during scanning.
Default speed is 40 inches/sec.

PUSHER LENGTH
– This is the length from the scan load side of the pusher to the process load
side of the pusher arm. See picture above. This value is used by the program to determine
where to drop the pusher after scanning. If the pusher is dropping on the end of the part increase
this value. Decrease this value if the pusher is dropping behind the part where the stock retaining
plate is not engaged. Default length is 13.5 inches.

CRAYON MARK OFFSET
– This offset determines where the saw cuts in relation the crayon
mark on the board. Default is 0 inches.

SENSOR DIFFERENCE
– Distance from board sensor to crayon sensor. Default is 1 inch.

BOARD SENSOR KERF
– The width of the end of board sensor detection area.

SCAN UNITS
– The scan units can be setup for encoder pulses or inches. Default is inches.

AFTER SCAN IS DONE
– This option changes the machine sequence after a scan. The first
option moves the RazorGage to the Run Start position then dropped the pusher arm. The
second (default) option is opposite. It drops the pusher arm and then move the RazorGage to
the Run Start position.

MINIMUM TRIM AT START
– This variable is the minimum trim amount if the board has no
crayon marks. This value cannot be smaller than the scan end of board gap (approximately
0.250”).
Default value is 0.750 inches.