Razorgage Cyclone RazorOptimal, Руководство пользователя

Страница: 15 / 55

Cyclone RazorOptimal User Manual
15 | P a g e
Technical Services, Inc.
Calibration Screen
NOTE: The scale factor will be set at the factory and only needs to be modified if the parts get
incrementally smaller or larger than nominal as the pusher advances.
Now that you have set the
Home Offset, the next step is to set the Scale Factor. Again, use the SAW STOP screen. Find the
longest, straightest piece of stock you can find and square one end. Measure the remaining length,
subtract an inch or two from it, and enter that length in the MOVE TO POSITION box. Highlight the
MOVE ONLY radio button and press GO. Now put the long piece of stock against the fence with the
squared end against the stop. Enter the same value into the MOVE TO POSITION box, highlight the
MOVE + SAW radio button and press GO.
The saw will cycle so make sure you’re clear and that
there are no tools or other obstructions in the way of the blade path . Now measure that part. Make
a note of the length you entered, the length of the actual part, and the current HOME OFFSET you set
in the previous step. Press DONE and from the MAIN SCREEN press MORE, PARAMETERS,
ENCODER. Record the SCALE FACTOR along with the other information mentioned above. Go to the
jump drive that came with your machine or go to our website,
www.razorgage.com/downloads and locate
the SCALE FACTOR CALCULATOR PROGRAM. Open the program and enter the information you
recorded and click CALCULATE. Enter the recommended scale factor in the ENCODER SCALE box on
the ENCODER screen of the PARAMETERS menu.
Encoder Parameters Scale Factor Calculator