11
Raz-AP/SP Dealer Manual
20170110
3.2 Molded Seat Depth Adjustment
The seat has approximately
2” of fore/aft adjustment.
Tool required: (1) #2 Phillips screwdriver
1. Release the seat by opening the plastic front seat brackets.
2. Remove the seat by lifting up on the front edge and sliding the
seat forward and away from the chair.
3. Loosen
(do not remove)
the eight screws attaching the front and
rear seat brackets to the underside of the seat.
4. Return the seat to the chair frame, nestling the front seat clamps
onto the front support tubes.
5. Slide/wiggle the seat to the desired position.
6. Tighten the screws just enough to hold the front seat clamps in
place, making sure the seat is positioned squarely on the frame.
7. With the seat on the chair, slide the rear brackets back until they
make firm contact with the rear cross tube, tighten the screws to
hold the brackets in place.
8. Tighten all eight screws.
3.3 Seat-To-Floor Height Adjustment
3.3.1 Seat-To-Floor Height Adjustment
– AP Model
The Raz AP Model has four telescopic caster extensions that provide a height adjustment range of 3
”.
1. Remove the snap-pin holding the caster extension tube in place, from the chair frame.
2. Slide the caster assembly to the desired position.
3. Align the holes in the caster extension tube with the frame holes and insert the snap-pins.
TIP: Locking the caster makes this easier.
4. Ensure that the pins are completely through the frame tube and that the green plastic clips
are snapped securely around the frame tubes.
5. Repeat steps 1 to 4 for all other casters on the chair.
IMPORTANT !
ALL CASTER STEMS MUST BE ADJUSTED TO THE SAME HEIGHT. NEVER ATTEMPT TO
CHANGE THE FRAME ANGLE BY ALTERING THE CASTER POSITION. UNEQUAL CASTER
POSITIONS WILL REDUCE THE CHAIR
’S STABILITY AND MAY RESULT IN TIPPING.
3.3.2 Seat-To-Floor Height Adjustment
– Front Casters of SP Model
The SP Model has two front caster extensions that provide a height adjustment range of
3” when
used with 24
” rear wheels and a 4” range when used with 22” rear wheels.
1. Remove the snap-pin holding the caster extension tube in place, from the chair frame.
2. Slide the caster assembly to the desired position.
3. Align the holes in the caster extension tube with the frame holes and insert the snap-pins.
TIP: Locking the caster makes this easier.
4. Ensure that the pins are completely through the frame tube and that the green plastic clips
are snapped securely around the frame tubes.
5. Repeat for the other caster.
