Raytheon Beechcraft Bonanza 35 Series, Руководство по ремонту

Страница: 472 / 493

BONANZA 35 SERIES SHOP MANUAL
Page 18
Aug 29/03
B21
Section 7
H. NOSE GEAR OPERATION (Continued) MECH INSP
4. GENERAL OPERATION - Place the airplane on jacks and cycle the landing gear while
checking to ascertain that the position light switches operate in conjunction with the
landing gear position. Check the condition and operation of the complete landing gear
system.
5. VISUAL INDICATOR - Inspect for proper adjustment and operation.
6. NOSE GEAR STEERING - Check for condition and security.
I. REAR FUSELAGE AND EMPENNAGE
1. SKIN - Check for deformation, cracks and obvious damage. Check for loose or missing
rivets. If damage is found, check adjacent structure.
2. INTERNAL FUSELAGE STRUCTURE - Check for cracks and deformation. Check for
loose or missing rivets. Check bulkheads, door posts, stringers and doublers for
corrosion, cracks and buckles.
3. STRUCTURE - Inspect the two most aft bulkheads for cracks, distortion, loose rivets or
other obvious damage.
4. CABLES, PULLEYS AND TURNBUCKLES - Check the flight control components,
cables and pulleys. Replace control system components (pushrods, turnbuckles, end
fittings, castings, etc.) that have bulges, splits, bends, or cracks. Check control cables,
pulleys, and associated equipment for condition, attachment, alignment, clearance and
proper operation. Replace cables that have more than 3 broken strands in any 3-foot
length of cable or evidence of corrosion. Check cables for proper tension.
NOTE - It is
important to operate controls through their full range so that the cables move away from
pulleys and all portions of the cables are exposed for inspection.
5. CONTROL SURFACES - Check for deformation, cracks and security. Check for loose
or missing rivets. Check for freedom of movement. Check for security of hinges and
bond cables.
6. TRIM TABS AND ACTUATORS - Check for security and wear. Check free play. Check
hinges and trim tab actuators for security and wear. Check trim tabs for cracks and
control rods for attachment. Lubricate trim tab hinges per Section 2.
7. STATIC PORTS - Check for obstruction and clean as necessary.
8. PLUMBING - Check for leakage, cracks, chafing, condition and security.
9. ELECTRICAL WIRING AND EQUIPMENT - Inspect for chafing, damage, security and
attachment.
10. STATIC LINES - Check condition of static lines and drain.
11. ASSIST STEP BUNGEE - Inspect for condition and attachment.
12. ANTENNAS - Check for condition and security.
13. ELEVATOR/RUDDER (Ruddervators) -
a. Check that the drain holes are open and clean.
b. Check that the ruddervator trim tab and hinge pin are correctly mated.
c. Check for cracks on the trim tab hinge support channel.
100-HOUR OR ANNUAL INSPECTION (Continued)