Raytheon Beechcraft Bonanza 35 Series, Руководство по ремонту

Страница: 463 / 493

BONANZA 35 SERIES SHOP MANUAL
Page 9
B21 Aug 29/03
Section 7
B. POWER PLANT (Continued) MECH INSP
5. SPARK PLUGS - Clean, inspect, regap, test and replace as necessary. Tighten spark
plugs to proper torque and check ignition harness condition and for proper attachment.
6. COMPRESSION - Perform cylinder leakage check per TCM Service Bulletin 03-3.
7. BATTERY - Inspect for clean, tight connections and add distilled water to maintain a
level of 3/8-inch above top of separators. Inspect the vents and overflow tube for
obstructions. Check for security and proper attachment. Check for corrosion. Make
certain the battery is clean. Water or dirt on battery surface can cause the battery to
discharge.
8. PLUMBING - Inspect plumbing and associated accessories for condition (such as
cracks and fraying) and attachment. Check plumbing clearance and secure against
possible chafing.
9. BRAKE FLUID RESERVOIR - Check reservoir for security, open vent, proper fluid level
and for leaks.
10. ENGINE OIL TANK OR SUMP - Check for cracks, leaks, proper fluid level, deformation
and security.
11. CRANKCASE - Check security of crankcase-thru bolts. Inspect the dipstick tabs for
security and that the tabs are not bent.
12. OIL SUMP DRAINS AND SCREENS - Clean screens, check for holes in the screens
and for obstructions. Check for metal particles or foreign matter on screens and filters.
Check for proper torque after installation.
13. OIL COOLER - Check oil cooler, lines and fittings for condition, security, chafing and
leaks.
14. PROPELLER AND MOUNTING HARDWARE - Check for condition and security.
15. PROPELLER BLADES - Inspect the blades for cracks, dents, nicks, scratches, erosion,
corrosion, security and movement in the hub. Check the tip of the blades for evidence
of lightning strikes. If there is evidence of lightning strikes, refer to the INSPECTION
AFTER LIGHTNING STRIKE procedure in this section.
16. PROPELLER HUB - Check for cracks, excessively leaking seals and condition. Refer
to publication 115187 for the 200 and 215 series Beechcraft propellers and publication
115090-19-1B for the 278 series Beechcraft propeller.
17. PROPELLER SPINNER - Check for deformation, security and cracks.
18. ALTERNATOR/GENERATOR - Check for condition and attachment. Check wiring for
proper attachment and possible chafing. Check for unusual noise.
19. ALTERNATOR - (Prestolite or Delco Remy only) Remove and disassemble the
alternator as necessary to inspect the rotor shaft bearings for condition and replace if
necessary. Refer to Beechcraft Service Instruction No. 0546-359 Rev II or subsequent.
20. ALTERNATOR/GENERATOR BELT- Check for proper tension and condition. Check
tightness of tension adjustment bolts.
21. STARTER - Check for condition, attachment and chafed or loose wires.
100-HOUR OR ANNUAL INSPECTION (Continued)