-30-
TellPhone 5000
Putting into operation for the first time
Pairing
A mobile phone that is to be operated on the handsfree system must be paired
with TellPhone 5000. To do this, both devices generate a common (secret)
passkey, which can be used in future for mutual authentication and to set up an
encrypted connection. One telephone can be paired per user, so that up to
4 devices in total are known. If you wish to pair an additional telephone, please
replace a user profile.
Inquiry
With TellPhone 5000, pairing starts automatically as soon as “Bluetooth” is
selected as the connection type when a user profile is created. The TellPhone
5000 then searches for mobile phones in its receiver's range. This process
takes approx. 10 sec. If your mobile phone is not found, please refer to the
“Handsfree mode” section for further information. If the name of your
telephone is displayed, select it via the “Accept” button. TellPhone 5000 will
now search for available services and, if possible, sets up a connection to an
appropriate service.
After a few seconds you will be prompted to enter the Bluetooth PIN. On the
telephone, enter the PIN shown on the TellPhone 5000 display.
Handsfree mode (handsfree profile)
Under certain circumstances, pairing with your telephone in handsfree mode
will not work using the method described above. If you are sure that your
telephone supports the Bluetooth handsfree profile, please proceed as follows:
In the list of found devices, select “Phone inquires”. You will now need to
search for Bluetooth devices from the telephone. Please refer to the
corresponding operating manual for details of how to proceed. The telephone
then starts device recognition. In the list of devices found by your telephone,
select “TellPhone 5000”. As the pairing procedure progresses, your telephone
will prompt you to enter a PIN or passkey (password). Enter the sequence of
digits shown on the TellPhone 5000 display. The telephone should shortly
register that the devices are paired. You can abort pairing at any time by
pressing the right-hand button. If pairing is unsuccessful, please refer to the
“Troubleshooting” section for further information.
Bluetooth
®
connection
If the telephone has been paired successfully but does not automatically
establish a connection to the handsfree system, select the name of the profile
in which the telephone was paired within user management. The first time
TellPhone 5000 is put into operation, this will be “User 1”. Now press the green
button. Connection to the telephone is established. The handsfree system will
always set up a connection when:
•
The ignition is switched on and the last telephone to be connected has
been found. If this telephone is not found, a search will be made for
potential paired telephones of other user profiles. If the search was
