-14-
TellPhone 5000
Installation
Option 2: Screwing
The base can also be attached using the two screws
enclosed. Use a stylus or a sharp object to mark the
positions of the base's screw slots on the dashboard.
Screw in the screws, but do not tighten them just yet.
Now push the base with the screw slots underneath
the screw heads and tighten the screws.
Mounting the Control Unit
The control unit is affixed inside the vehicle at a point that is within easy reach.
Find the installation position that suits you best. Sit behind the steering wheel
as normal and find a position in which you can reach the control unit easily at all
times. It does not matter whether or not you are able to see the control unit as
it is operated. Make sure there is enough space next to the control unit to be
able to press the release button on the side, (i.e. approx. a finger width).
Adhesive surfaces must be free of grease and dust. Clean the designated
surface with a suitable detergent such as spirits. Only use detergents which do
not dissolve plastics or varnished wooden surfaces and which are not greasing
themselves. Unsuitable agents are e.g. cleaning grade petrol, acetone,
turpentine, trichloroethylene and similar detergents.
Remove the protective film from the adhesive strip. Hold the control unit a few
millimetres above the required mounting position. Check the position again.
Once the part is stuck down, it will not be possible to correct it later. Place the
control unit onto the adhesive surface and briefly apply moderate pressure.
Inserting the battery
Press the release button on the side (beneath the green button)
and lift off the top section. With the positive terminal
downwards, insert the supplied battery into the bottom section
until you hear it lock in place. Now replace the top section.
Make sure you hear it latch.
