RayTek LineScanner MP150, Руководство по протоколу

Страница: 35 / 42

Appendix
MP150 Protocol
Rev. B4 Aug 2019
35
Description Code Para-
meter
Explanation Factory
default
Firmware
Revision
bit-1: checksum error in the cali parameter
section
→
%PS
bit-2: checksum error in the temperature
table section
→
%TTS
bit-3: device in warm-up → wait some
minutes
bit-4: bias voltage out of range
bit-5: checksum error in the service
parameter section
→ service / may be
ignored
bit-30: no zero-pulse is arriving from the
encoder – probably the motor is not
rotating
bit-31: motor is rotating but no data is
arriving at the ad-converters
Get the actual
Current FreQuency
GFQC - the FQ
parameter
3.48
Get Identifier GID - Returns scanner identifier
(test SW returns
ID-RAY-M150-000-TEST0-) -
Get Internal Max.
temperature
GIM - Returns the maximal allowed internal
temperature
60 3.22
MAC address GMAC - Read only; returns Hardware (MAC)
address; format: xx:xx:xx:xx:xx:xx, where
xx is hexnumber 00-FF;
returns 00:00:00:00:00:00 if not set
00:1D:8D:xx:xx
:xx
Get Range Bottom GRB - Returns min. temp range (°C) model
dependent
Get Range Full GRF - Returns max. temp range (°C) model
dependent
Get Range Zoom GRZ - Returns min. temp sub-range (°C) - legacy
support:
GRZ = GRF
Get Hold Value GSH n n=1..3: sector/interface
returns current zone value
-
Get Service
Parameter
GSP t1 t2 T1
T2
t1 = runtime accumulated
t2 = max. runtime without reset
T1 = min. internal temperature
T2 = max. internal temperature
-
Get Sec. Value GSV n n=1..3: sector/interface Returns current
sector value
-
Get Version
Message GVM - Returns software version number -
Hold Mode HM nd n=1..3: sector/interface d=0: no Hold
Function
d=1: Hold Value for certain time (HT)
d=2: Hold value until trigger
0