GP Monitor
GP Series
Rev. F 10/2011
29
Thermocouple output is available for H004 and H005 only
if either °C or °F is activated!
3.4.7
Signal Processing
The Peak Hold,Valley Hold, and Average times are factory set at 0
seconds and are not activated. If you don’t need to use these signal
processing functions, no adjustments are necessary.
Only one signal processing setting can be active at a time!
To set and activate, complete the following steps:
1.
Press and hold the
button and press the button and release
them both. The Peak Hold display appears:
Figure 20: Peak Hold Display
2.
Press the
button again and the display shows the current Peak
Hold value in seconds.
3.
Set the display by using the
and
buttons. Note that “000”
turns off Peak Hold.
4.
Press the button again and the Valley Hold display appears.
Содержание GP Series
Страница 1: ...GP Series Operating Instructions Rev F 10 2011 54201...
Страница 2: ......
Страница 7: ......
Страница 72: ...Notes GP Series Rev F 10 2011 65 8 Notes...