Raypak RSIT115, Инструкция по установке и эксплуатации

Страница: 4 / 20

4
WARNING: Improper installation, adjustment,
alteration, service or maintenance can cause serious
injury or property damage. Refer to this manual. For
assistance or additional information, consult a
qualified installer or service agency.
CAUTION: The recommended water temperature
for normal residential use is 120°F. The control
temperature setting does not always reflect the
outlet water temperature, which could occasionally
exceed 120°F. The variation in outlet temperature
could be based on factors including but not limited to
usage patterns and type of installation. Test your
water at the tap nearest to the indirect water heater.
SAFETY WARNINGS
INTRODUCTION
BEFORE INSTALLATION
Raypak strongly recommends that this manual be re-
viewed thoroughly before installing your Indirect Fired
Storage Water Heater. Please review the General
Safety information before installing the unit. Factory
WARNING: Hotter water increases the risk of scald
injury. Before adjusting the water temperature
setting, read this instruction manual. Temperatures
at which injury occurs vary with the person’s age and
the length of exposure.
The slower reaction time of children, elderly, and
physically or mentally-challenged persons increases
the scalding hazard to them. It is recommended that
lower water temperatures be used where these
exposure hazards exist. Such households may
require a temperature setting less than 120°F to
prevent accidental contact with hot water.
To lower water temperature, use point-of-use
temperature limiting devices.
warranty does not apply to units that have been improp-
erly installed or operated. (Refer to the warranty at the
back of this manual.) Installation and service must be
performed by a qualified installer, or service agency. If,
after reviewing this manual, you still have questions
which this manual does not answer, please contact your
local Raypak representative or visit our website at
www.raypak.com . Keep this manual with the water
heater after installation.
Local plumbing and electrical codes must be followed
in the installation of this indirect water heater. In the ab-
sence of a local code, use the UNIFORM PLUMBING
CODE and the NFPA Code. Local codes may super-
sede instructions in this installation manual.
Thank you for purchasing a Raypak® product. We hope
you will be satisfied with the high quality and durability
of our equipment.
Product Receipt
On receipt of your unit it is suggested that you visually
check for external damage to the shipping carton. If the
carton is damaged, make a note to that effect on the Bill
of Lading when signing for the shipment. Next, remove
the water heater from the carton. Report any damage
to the carrier immediately.
On occasion, items are shipped loose. Be sure that you
receive the correct number of packages as indicated on
the Bill of Lading.
Claims for shortages and damages must be filed with
the carrier by consignee. Permission to return goods
must be received from the factory prior to shipping.
Goods returned to the factory without an authorized Re-
turned Goods Receipt number will not be accepted. All
returned goods are subject to a restocking charge.
The Raypak indirect water heater uses heat from a boiler to heat domestic water. The heat is transferred to the
water by a coil heat exchanger inside of the tank. The indirect storage tank stores the energy from the boiler for
use later. With the excellent thermal insulation in the Raypak water heater, the boiler turns on and off less often.
To maintain energy efficiency the stainless steel tank is fully insulated with 2 inches of rigid foam. The Raypak in-
direct water heater is an efficient means of heating water.
This indirect water heater has all stainless steel construction. The stainless steel tank is fully welded, pickled and
passivated. The stainless steel resists corrosion assuring a long service life.