Raypak CROSSWIND Series, Инструкция по установке и эксплуатации

Страница: 18 / 28

18
On/Off Models Only
The Display controls general operation. The layout, main
functions and buttons are shown below.
TIMER ON
MODE
TIMER INDICATOR
LIGHT
TIMER
INDICATOR
LIGHT
POWER ON/OFF TIMER OFF
WATER TEMP
AND
TIME SETTING
CLOCK
Heat
Cool
Figure 13. Operation Display, Models 40-O through 65-O
Symbol Designation Button Functions
Power Power Switch
Clock Set local time
Timer Off
Set the time required machine
auto-stop
Light A Shows the auto-stop time being set
Timer On
Set the time required machine
auto-work
Light B Shows the auto-work time being set
Cool
Shows the cool mode (for heat and
cool models only)
Heat Shows the heat mode
MODE
MODE Key
Heat or cool mode selection (only
available in heat and cool machine)
Down-
ALLOW
Set required temperature and time
Up-ALLOW Set required temperature and time
LED screen
Display time, temperature and
machine failure code
Table F. Display Button Functions
Using the On/Off Display Unit
Display defaults
• The LED screen will display the time when the
machine is off.
• The LED screen will display the current water
temperature in the pool when the machine is on.
Heat/Cool Mode
1. Press the MODE button to switch from one mode to
another.
NOTE: Available only in heat and cool models.
Setting pool water temperature
Temperature can be adjusted either when the machine is
on or off.
1. Press UP or DOWN to set to your required
pool water temperature.
2. The numbers on the LED screen will flash during
adjustment.
3. After five seconds of inactivity, the LED will stop
flashing, the adjusted target temperature will be
saved, and the LED screen will revert to the default
display.
4. Later on, at any time, should you wish to check the
temperature, press UP or DOWN again to
access its setting.
Setting the clock
1. The clock can be set either when the machine is on
or off.
2. Press CLOCK to set the time to your local time
zone. The displayed time on the LED screen will now
flash.
3. To set the hour press CLOCK again then press
UP or DOWN .
4. To set the minute press CLOCK before it stops
flashing and then press UP or DOWN .
5. After setting, press CLOCK and the water
temperature will appears. After 30 seconds, it will
stop flashing and the LED screen will return to its
default.
Automatic on/off settings
The display can be programmed to turn the machine on
and off automatically.
Setting the ON time
1. Press CLOCK to access the timer function.
2. When the indicator light is on and the time is flashing,
press CLOCK again to set the hour. Use UP
or DOWN to adjust.
3. While the display is still flashing, press to set
minute. Use UP or DOWN to adjust.
4. After adjustment, press TIMER ON to confirm the
setting, and the water temperature will be displayed.
After 30 seconds, the controller display will be revert
to its default mode.
6100.64_Crosswind.indd 18 11/26/2019 4:16:49 PM