4. "Setup"
EN
| 39
4.7 Initialising a Memory Card
Setup Number: 44
If you should come upon a memory card with illegible sticker, you can test the card with this setup function
and reinitialise it. The function works for the memory cards of the bioresonance according to Paul Schmidt
and also for the "Green Card".
When initialising the memory card with this function, the system values of the card are newly determined
and written and all the stored RAH-programs are deleted. If the card is write protected, this is also deleted.
Please insert the memory card intended for initialisation in your Rayocomp PS 10. Enter the setup number
44 and wait until a 0 is displayed. For safety reasons, you must enter a 1 at this stage and confirm with
the
OK key.
4.8 Motor Test Run of the Frequency Module
Setup Number: 50
The user can test the mechanically driven frequency module of the Rayocomp PS 10 with this setup
function. If your Rayocomp has been subject to jostling and vibration, perhaps during long transportation,
you can make sure that the frequency module is still in perfect working order with this function.
After you have entered the setup number 50 and confirmed your entry with the
OK-key, the Rayocomp
PS 10 starts a trial run. You can read the progress of the trial run from your display. At the end, the device
should display the following message:
The 1 displayed behind the 50 indicates an optimal
functioning of the frequency module. If you see
a 0 in the same place, however, the trial run was
faulty. Please repeat the trial run in this case. If the
0 appears again, your Rayocomp PS 10 has to be
sent back to us.
