4. "Setup"
36 |
EN
4.3 Activating and Deactivating Modules
Setup Number: 20
After having entered the set-up number 20, you can select the number of the module (10) intended for
activation or deactivation. (Please confirm each input with the OK-key.)
Here is the module number:
Module no. Designation
10
Rayonex Analysis and Harmonising program (RAH), Module 10
Then please enter a seven-digit activation code, which you will receive from Rayonex, for activation or
deactivation and confirm it with the
OK button.
4.2 Adjusting the "Attention" sound (Beep)
Setup Number: 12
The Rayocomp PS 10 has been equipped with an acoustic signal. This may signalise e.g. the use of a wrong
key or confirm an entry.
The Rayocomp PS 10 has three different error messages or acoustic signals:
1.
One long sound:
with this signal, the device confirms a successfully completed action, i.e. an entry or
storage.
2.
Two short sounds:
The key you are pressing has no current function.
3.
Two long sounds:
This signalises a severe error. The device will supply an error code. In the appendix
(Chapter 5.2), you can look up the current error.
This set-up function enables or disables the signal. Enter the set-up number 12 and you can add one of
the following numbers:
1: The acoustic signal is switched on.
0: The acoustic signal is switched off.
On delivery, the standard set-up of the Rayocomp PS 10 is number 1.
