27
To Open the Door Manually
Disconnect Trolley:
The door should be fully closed
if possible. Pull down on the
emergency release handle (so
that the trolley release arm
snaps into a vertical position)
and lift the door manually.
The
lockout feature
prevents the
trolley from reconnecting
automatically, and the door can
be raised and lowered manually
as often as necessary.
To Re-Connect the Trolley:
Pull the emergency release
handle toward the opener at a
45° angle so that the trolley
release arm is horizontal. The
trolley will reconnect on the
next UP or DOWN operation,
either manually or by using the
door control or remote.
To prevent possible SERIOUS INJURY OR DEATH from a falling
garage door:
If possible, use emergency release handle to disengage
•
trolley ONLY when garage door is CLOSED. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
NEVER use emergency release handle unless garage doorway
•
is clear of persons and obstructions.
NEVER use handle to pull door open or closed. If rope knot
•
becomes untied, you could fall.
Using the Wall-Mounted Door Control
The Multi-Function Door Control
Press the push bar to open or close the door.
Press again to reverse the door during the
closing cycle or to stop the door while it’s
opening.
Light feature
Press the Light button to turn the opener light
on or off. It will not control the opener lights when the door is in
motion. If you turn it on and then activate the opener, the light will
remain on for 4-1/2 minutes. Press again to turn it off sooner. The
4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2
minutes as follows: Press and hold the Lock button until the light
blinks (about 10 seconds). A single blink indicates that the timer
is reset to 1-1/2 minutes. Repeat the procedure and the light will
blink twice, resetting the timer to 2-1/2 minutes. Repeat again for
a 3-1/2 minute interval, etc., up to a maximum of four blinks and
4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from hand-held remote
controls. However, the door will open and close from the Door
Control, the Outside Keylock and the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds. The
push bar light will flash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds.
The push bar light will stop flashing. The Lock feature will also
turn off whenever the “Learn” button on the motor unit panel is
activated.
Additional features when used with the 3-Button hand-held
remote
To control the opener lights:
In addition to operating the door, you may program the remote to
operate the lights.
With the door closed, press and hold a small
1.
remote button that you want to control the
light.
Press and hold the Light button on the
2.
Multi-Function door control.
While holding the Light button, press and hold the Lock button
3.
on the door control.
After the opener lights flash, release all buttons.
4.
LOCK
LIGHT
Push
Button
Lock
Button
Light
Button
TO RECONNECT
LOCKOUT POSITION
(MANUAL DISCONNECT)
NOTICE
Emergency
Release Handle
(Pull at 45
°
angle)
Trolley
Release
Arm
Trolley
NO
TICE
Trolley Release
Arm (in Manual
Disconnect Position)
Trolley
