13
Carriage Bolt
1/4"-20x1/2"
Lens
Wing Nut
1/4"-20
Figure 5
Wing Nut
1/4"-20
Staples
Carriage Bolt
1/4"-20x1/2"
HARDWARE SHOWN ACTUAL SIZE
Invisible Light Beam
Protection Area
Safety Reversing
Sensor
Safety Reversing Sensor
Bell Wire
Sensor Wire
Wire Clips
Rail
Figure 6
Mounting and Wiring the Safety Reversing Sensors
Slide a 1/4"-20x1/2" carriage bolt head into the slot on each
•
sensor. Use wing nuts to fasten sensors to brackets, with
lenses pointing toward each other across the door. Be sure the
lens is not obstructed by a bracket extension (Figure 5).
Finger tighten the wing nuts.
•
Recommended Wire Routing
Using insulated staples, run the wires from both sensors to the
1.
rail at the door header (Figure 6).
Run the wires through wire clips at the top of the rails.
2.
NOTE:
If your access door is near the garage door, you may
choose to install the door control at this time and run the door
control wire along the rail with the sensor wires.
