Raymarine ST60+ SPEED INSTRUMENT, Руководство пользователя

Страница: 15 / 60

Chapter 1: Operation 3
The screens show the maximum/minimum depth since the last reset, but time out
to the current depth screen if no user action occurs for 8 seconds.
Alarms
An alarm condition occurs if:
• The depth is less than the
SHALLOW or SHALLOW anchor level.
• The depth is more than the DEEP anchor level.
• The DEEP level value is crossed (when the seabed rising or falling).
An alarm condition is indicated by an audible beep and a flashing alarm
symbol ( ) on the display. The display will also show the relevant caption, either
SHALLOW or DEEP , and for anchor alarms an anchor symbol ( ) .
Shallow alarm
Deep
alarm
Shallow anchor
alarm
Deep anchor
alarm
To adjust an alarm level:
Depth alarms
alarm
reset
To enable/disable any alarm, select the
relevant screen then hold down
for 1 second
reset offset
+
Select relevant
screen then press
to enter adjust mode.
reset offset
or
In adjust mode, use
either
to set the alarm level
To leave adjust mode
1. 2.
reset offset
+
Press
= Alarm enabled = Anchor alarm
You can change the shallow alarm
only if the shallow alarm lock is set
OFF during User calibration
alarm
alarm
alarm
alarm
Note:
You can access alarm screens only at master instruments.
On repeaters, the
alarm button has no effect.
D8162-1
81262_2.book Page 3 Friday, November 11, 2005 11:11 AM