Raymarine SmartPilot Verado, Руководство по установке и пусконаладке

Страница: 48 / 72

38 SmartPilot Verado Installation and Commissioning Guide
Note: To prevent accidental access, we have made entry to Dealer Calibration more difficult than the
other groups. After pressing
auto
, the display will show CAL ?. When you see this, press the
-1
and
+1
keys together to enter Dealer Calibration.
4. When you have entered one of the Calibration groupings, press
disp
key to scroll down
through the items within that grouping.
Note:
You can go backwards through the list by pressing and holding the disp key for one second.
5. When you reach an item you wish to adjust, use the -1, +1, -10 and +10 keys to change
the value.
6. If you then want to adjust settings in another Calibration group, press standby and then
repeat steps 2 to 5 as necessary.
7. When you have made all the changes you want to make, press and hold standby for two
seconds to exit Calibration mode and save changes.
Display calibration screens
Display bar selection
This screen allows you to select what information is displayed at the bottom of the SmartPilot
display.
Heading selection
This screen allows you to display any heading as either a magnetic or true value. During
normal SmartPilot operation the screen will indicate MAG for magnetic headings and TRUE
for true headings.
Options
RUDD BAR (Default) Rudder position bar. It uses the bar graph to show the true rud-
der angle. Requires rudder position sensor for accurate rudder
information.
The Verado system does not require a rudder position sensor.
Rudder position is sensed electronically and indicated on the
controller display only when the controller is in Auto mode.
STEER BAR This setting uses the bar graph to indicate different information
in different operating modes:
STANDBY: No rudder display (Verado)
AUTO: heading error bar (in 2° increments)
TRACK: cross track error (XTE) bar (in 0.02 nm increments)
WIND VANE: wind angle error bar (in 2° increments)
BAR OFF No bar is displayed