Raymarine S1 Tiller Pilot, Руководство по эксплуатации

Страница: 22 / 58

12 S1 Wheel and Tiller Pilots Operating Guide
• To AutoTack to starboard:
i. Press the
+1
and
+10
buttons together. The boat will then AutoTack.
ii. Use the
1
and
10
buttons to trim the helm back to the required wind
angle.
AutoTack angle
You should set the AutoTack angle to 20° greater than the actual required change
of heading.
Example
If you wish to tack through 80° (i.e when sailing at 40° to the wind) you should set
the AutoTack angle to 100°. The SmartPilot will AutoTack through the larger
angle, you should then use the SmartPilot controls to trim the helm back to the
required 40° relative to the wind.
You can adjust the default AutoTack angle in User Calibration (see
page 30
).
Preventing gybes with AutoTack
The gybe inhibit feature prevents an AutoTack away from the wind – this will
prevent the AutoTack feature from gybing.
Note:
For the gybe inhibit feature to work, the SmartPilot needs suitable wind informa
tion.
Gybe inhibit is switched on as a default but can be disabled in User Calibration if
required
(see page 30)
.
AutoTack - Starboard
D9318-1
+
+
Wind Wind
AutoTack - Port
AutoTack
angle
AutoTack
+
Helm trim
AutoTack
+
Helm trim Helm
trim
Helm
trim
AutoTack
angle
81283_1.book Page 12 Monday, October 2, 2006 2:03 PM